FreeEvery fee straight from the official city and county fee schedules. No signup.

Bell, FL Permit Fees (2026)

Building permit fees and building, electrical, plumbing, mechanical/HVAC, and roofing permit fees for Bell, straight from the official fee schedule, with a free permit fee calculator below.

Gilchrist County administers building permits for the Town of Bell under a June 3, 2024 interlocal agreement; permits are issued by the county at the county's fee schedule. Applicants first obtain a Town of Bell zoning approval certificate; the town publishes no fee for it. The county's $100 land use compliance review appears on new construction estimates here, but it likely does not apply inside Bell, where the town does its own zoning. See the Gilchrist County fee schedule

In Bell, a building permit for a remodel runs $104.00 in permit fees, a $20,000 re-roof $129.00, an HVAC change-out $99.00, and an electrical panel upgrade or rewire $99.00. Totals include the documented surcharges and minimum fees; where the schedule prices by unit, figures assume a 200 sq ft remodel area, one system, and 200 A service. Each figure is that single permit only: a job that combines trades, like a kitchen remodel with electrical and plumbing work, pays each applicable permit. Pick a project to load it in the calculator below.

Jump to Permit Fee Calculator
Source

Gilchrist County Community Development Building and Zoning Fee Schedule (April 2024) and Building Fees update (October 2022)

Covers building, electrical, plumbing, mechanical/HVAC, and roofing permits. Minimum permit fee: $95.00.

Gilchrist County administers building permits for the Town of Bell under a June 3, 2024 interlocal agreement; permits are issued by the county at the county's fee schedule. Applicants first obtain a Town of Bell zoning approval certificate; the town publishes no fee for it. The county's $100 land use compliance review appears on new construction estimates here, but it likely does not apply inside Bell, where the town does its own zoning. See the Gilchrist County fee schedule

Apply online at the Bell permit portal, or call 352-463-3173.

Schedule effective May 30, 2022. Last verified: September 26, 2026

This schedule predates Florida's HB 803 (July 2026). Jurisdictions statewide are adopting updated schedules; we check sources weekly. What HB 803 changed

Bell Permit Fee Schedule

Every documented rule for each permit type, straight from the official schedule.

Roofing Permit Fees in Bell

Residential (1–2 family)
$125.00 flat
Commercial / 3+ units
$6.00 per square (100 sq ft)
State Building Code Administrators Surcharge (F.S. 468.631)
1.5% of the permit fee, minimum $2.00†
State Building Permit Surcharge (F.S. 553.721)
1% of the permit fee, minimum $2.00†
Re-Inspection Fee (if applicable)
$65.00 per inspection

† Corroborated across official sources, but not printed line-for-line in the linked schedule.

Sponsor This Page
Be the Featured Roofer in Bell

Homeowners and contractors planning a project check Bell roofing permit fees here first. One sponsor per trade, flat monthly rate.

Advertise on This Page

Bell Permit Fee Calculator

Pick a permit type and adjust the job value. Total updates instantly, itemized below.

Permit type
Project type
Kind of work
Estimated roofing permit fee
$129.00
Included in this total
Roofing Permit Fee$125.00
$125.00 flat
State Building Code Administrators Surcharge (F.S. 468.631)$2.00
State Building Permit Surcharge (F.S. 553.721)$2.00
Total Estimate$129.00

Permit fees for Bell are administered by Gilchrist County; the fees shown are the Gilchrist County schedule.

Estimate only. Confirm with the Gilchrist County building department before applying. Apply online. Phone: 352-463-3173. Permit fees only; excludes impact fees, utility connection charges, and other non-permit charges.

Sponsor This Page
Be the Featured Roofer in Bell

Homeowners and contractors planning a project check Bell roofing permit fees here first. One sponsor per trade, flat monthly rate.

Advertise on This Page

How to Apply for a Permit in Bell

Gilchrist County issues building permits for property inside the Town of Bell under the interlocal agreement the county adopted on June 3, 2024. Applicants must first obtain a zoning approval certificate from the Town of Bell and present it to the Gilchrist County Building Department. Then apply through the county's online permitting portal, by email to permitting@gilchrist.fl.us, or in person at 209 SE 1st Street, Trenton. Request inspections through the county portal or the county inspection line at 352-463-4171.

Source: Bell application instructions

Apply online: Bell permit portal
Building Department Contact
Inspection line
352-463-4171
Building Official
Gene Stockman, 352-463-4620, inspector@gilchrist.fl.us
Address
209 SE 1st Street, Trenton, FL 32693
Hours
Monday to Thursday 8:00 a.m. to 5:00 p.m. (closed 12:00 to 1:00 p.m.); Friday 8:00 a.m. to 4:00 p.m.

Bell Permit Fee FAQs

How Much Does a Building Permit Cost in Bell?

The building permit for a residential remodel runs $104.00, assuming a 200 sq ft remodel area (the schedule prices per unit), including the documented surcharges and minimum fees. The estimate is built from Bell's sourced fee schedule, and it covers the building permit alone; a job that combines trades pays each applicable permit. Calculate your job's value for an itemized total.

How Much Does a Roofing Permit Cost in Bell?

The roofing permit for a $20,000 residential re-roof runs $129.00, based on Bell's sourced fee schedule.

How Are Permit Fees Calculated in Bell?

A residential building permit is $0.10 per sq ft under roof, minimum $100.00. Electrical permits are priced per amp; Plumbing permits are priced per bath; Mechanical / HVAC permits are priced per system; Roofing permits are flat fees. New construction is priced separately from remodel and alteration work; the calculator asks which kind of job yours is. Every rate comes straight from the sourced fee schedule above. Enter your job's details for an itemized total.

What Is the Minimum Permit Fee in Bell?

The sourced schedule sets a minimum permit fee of $95.00; small jobs pay at least that much before surcharges. The calculator applies it automatically.

What Surcharges Are Added to Permits in Bell?

On top of the base permit fee, the sourced schedule adds State Building Code Administrators Surcharge (F.S. 468.631) (1.5% of the permit fee, minimum $2.00) and State Building Permit Surcharge (F.S. 553.721) (1% of the permit fee, minimum $2.00). These are included in every estimate on this page.

Do I Need a Permit for a Small Residential Job in Bell?

Florida's HB 803 (effective July 2026) exempts certain single-family work under $7,500 from permitting statewide, excluding electrical, plumbing, structural, mechanical, and gas work. Confirm with the building department whether your job qualifies before skipping a permit. Read what HB 803 changed and what it saves.

Where Do These Fees Come From?

Every figure on this page is sourced from Gilchrist County Community Development Building and Zoning Fee Schedule (April 2024) and Building Fees update (October 2022). See the official schedule. Last verified .

Other Jurisdictions in Gilchrist County

Jobs inside another city's limits are permitted by that city; unincorporated areas by the county.

New to Florida permit fees? Read our Florida permit fee guide: how schedules are set, the statutory surcharges, and what HB 803 changed in 2026. Pulling a commercial permit or a small residential job? See what HB 803 lets you save. Wondering whether fees changed this year? See which Florida fee schedules are new.

Contact

Get in Touch

Missing a jurisdiction? Spotted a fee that looks off? Request coverage for a city or county, report an issue, or ask about sponsorship. We typically reply within one business day.