FreeEvery fee straight from the official city and county fee schedules. No signup.

Garden Ridge, TX Permit Fees (2026)

Building, electrical, plumbing, mechanical/HVAC, and roofing permit fees for Garden Ridge, straight from the official fee schedule, with a free permit fee calculator below.

A note on these figures from the official schedule. Details

Commercial building permit and plan review fees are set by a valuation table that this estimate does not yet include; contact the City. Work started before a permit is issued is charged double fees per trade, $500 minimum. The City Council considers a replacement fee schedule on December 2, 2026; this page shows the schedule in force now. The schedule prints no fee for an interior remodel, so this page shows none; ask the City.

In Garden Ridge, a $20,000 re-roof runs $400.00 in permit fees, a $10,000 HVAC change-out $150.00, a $10,000 electrical panel upgrade or rewire $150.00, and a $10,000 whole-house repipe $150.00. Totals include the documented surcharges and minimum fees. Each figure is that single permit only: a job that combines trades, like a kitchen remodel with electrical and plumbing work, pays each applicable permit. Pick a project to load it in the calculator below.

Jump to Permit Fee Calculator
Source

City of Garden Ridge Ordinance No. 11-042026, Attachment 1 Schedule of Fees (passed April 1, 2026)

Covers building, electrical, plumbing, mechanical/HVAC, and roofing permits.

Call the building department at (210) 651-6632.

Last verified: November 20, 2026

Garden Ridge Permit Fee Schedule

Every documented rule for each permit type, straight from the official schedule.

Building Permit Fees in Garden Ridge

Residential (1–2 family): New single-family home or duplex
$1.30 per sq ft (foundation, covered first floor and second floor)
Residential (1–2 family): Home addition or attached garage, patio, porch or carport
$1.30 per sq ft (foundation, covered first floor and second floor)‡
Above-ground pool (flat fee)
$200.00 flat
Carport (flat fee)
$400.00 flat
Demolition permit (flat fee)
$500.00 flat
Fence (flat fee)
$100.00 flat
Flatwork or deck (flat fee)
$300.00 flat
Foundation repair (flat fee)
$500.00 flat

‡ Awaiting confirmation from the jurisdiction.

Sponsor This Page
Be the Featured General Contractor in Garden Ridge

Homeowners and contractors planning a project check Garden Ridge building permit fees here first.

One sponsor per trade, flat monthly rate.

Garden Ridge Permit Fee Calculator

Pick a permit type and adjust the job value. Total updates instantly, itemized below.

Permit type
Project type
Kind of work
Job type

No standard rate for this permit type; the schedule prices only these 10 job types.

No standard building rate for this project type. Garden Ridge's schedule prices only 10 specific job types. Pick one under Job type above to see its fee.

A note on these figures from the official schedule. Details

Commercial building permit and plan review fees are set by a valuation table that this estimate does not yet include; contact the City. Work started before a permit is issued is charged double fees per trade, $500 minimum. The City Council considers a replacement fee schedule on December 2, 2026; this page shows the schedule in force now. The schedule prints no fee for an interior remodel, so this page shows none; ask the City.

Estimate only. Confirm with the Garden Ridge building department before applying. Phone: (210) 651-6632. Permit fees only; excludes impact fees, utility connection charges, and other non-permit charges.

Sponsor This Page
Be the Featured General Contractor in Garden Ridge

Homeowners and contractors planning a project check Garden Ridge building permit fees here first.

One sponsor per trade, flat monthly rate.

How to Apply for a Permit in Garden Ridge

Garden Ridge's Building Inspector reviews all plans and applications; building permits are issued only after the plans are reviewed and approved. The City says it is updating its permit process and online permit system, and its Building Forms page is under construction, so contact Building Inspections at (210) 651-6632 or buildinginspections@ci.garden-ridge.tx.us for current application instructions. Pay permit fees as stated on the Fee Schedule through the City's Pay Your Building Permit page at municipalonlinepayments.com/gardenridgetx. All contractors, irrigation installers and backflow inspectors working in the City must hold a State of Texas license.

Source: Garden Ridge application instructions

Building Department Contact
After-hours phone
(210) 651-6831
Address
9400 Municipal Parkway, Garden Ridge, TX 78266
Hours
Monday to Friday, 8 AM to 4 PM (public lobby)
Sponsor This Spot · Permit Help
Be the Featured Permit Expediter in Comal County

Your name, phone and website right here, next to the building department's contact info, where people look right before they apply.

One expediter per county.

Garden Ridge Permit Fee FAQs

How Much Does a Roofing Permit Cost in Garden Ridge?

The roofing permit for a $20,000 residential re-roof runs $400.00, based on Garden Ridge's sourced fee schedule.

How Are Permit Fees Calculated in Garden Ridge?

Electrical, Plumbing, Mechanical / HVAC, and Roofing permits are flat fees. New construction is priced separately from remodel and alteration work; the calculator asks which kind of job yours is. Every rate comes straight from the sourced fee schedule above. Enter your job's details for an itemized total.

Where Do These Fees Come From?

Every figure on this page is sourced from City of Garden Ridge Ordinance No. 11-042026, Attachment 1 Schedule of Fees (passed April 1, 2026). See the official schedule. Last verified .

Other Jurisdictions in Comal County

Jobs inside another city's limits are permitted by that city; unincorporated areas by the county.

Contact

Get in Touch

Missing a jurisdiction? Spotted a fee that looks off? Request coverage for a city or county, report an issue, or ask about sponsorship. We typically reply within one business day.