PermitFees.org
FreeEvery fee straight from the official city and county fee schedules. No signup.

Cut and Shoot, TX Permit Fees (2026)

Building permit fees and building, electrical, plumbing, mechanical/HVAC, and roofing permit fees for Cut and Shoot, straight from the official fee schedule, with a free permit fee calculator below.

Residential remodels and additions need no city building permit, so no estimate is shown for them. Work started without a permit pays double the permit fee. Commercial work of $50,000 or more also registers with the Texas Department of Licensing and Regulation (fee paid to the state).

Roofing Permit
$110.00
$20,000 re-roof
Open in calculator
HVAC Permit
$220.00
$10,000 change-out
Open in calculator
Electrical Permit
$220.00
2 county-assigned inspections
Open in calculator
Plumbing Permit
$220.00
2 county-assigned inspections
Open in calculator

In Cut and Shoot, a $20,000 re-roof runs $110.00 in permit fees, a $10,000 HVAC change-out $220.00, an electrical panel upgrade or rewire $220.00, and a whole-house repipe $220.00. Totals include the documented surcharges and minimum fees; where the schedule prices by unit, figures assume 2 county-assigned inspections. Each figure is that single permit only: a job that combines trades, like a kitchen remodel with electrical and plumbing work, pays each applicable permit. Pick a project to load it in the calculator below.

Jump to Permit Fee Calculator
Source

City of Cut and Shoot Ordinance No. 135, Municipal Building Permit Inspection-Plan Review Fee Schedule (Exhibits A and B)

Covers building, electrical, plumbing, mechanical/HVAC, and roofing permits.

Official Fee Schedule

Call the building department at (936) 264-3100.

How Cut and Shoot values a job: Commercial valuation follows the ICC Building Valuation Data table (August 2012) for new buildings and additions, and project valuation for alterations and build-outs, as determined by the building official.

Schedule effective April 29, 2021. Last verified: November 3, 2026

Cut and Shoot Permit Fee Schedule

Every documented rule for each permit type, straight from the official schedule.

Building Permit Fees in Cut and Shoot

Residential (1–2 family): New home
tiered rates by sq ft (Printed band total: permit, $50 base and plan review)‡
Up to 999 sq ft
$770.00
Over 999, up to 1,499 sq ft
$1,084.00
Over 1,499, up to 1,999 sq ft
$1,369.00
Over 1,999, up to 2,499 sq ft
$1,624.00
Over 2,499, up to 2,999 sq ft
$1,849.00
Over 2,999, up to 3,499 sq ft
$2,044.00
Over 3,499, up to 3,999 sq ft
$2,209.00
Over 3,999, up to 4,499 sq ft
$2,344.00
Over 4,499, up to 4,999 sq ft
$2,450.00
Over 4,999, up to 5,499 sq ft
$2,607.00
Over 5,499, up to 5,999 sq ft
$2,750.00
Over 5,999, up to 6,499 sq ft
$2,877.00
Over 6,499, up to 6,999 sq ft
$2,990.00
Over 6,999, up to 7,499 sq ft
$3,087.00
Over 7,499, up to 7,999 sq ft
$3,170.00
Over 7,999, up to 8,499 sq ft
$3,237.00
Over 8,499, up to 8,999 sq ft
$3,290.00
Over 8,999, up to 9,999 sq ft
$3,500.00
Over 9,999, up to 11,000 sq ft
$3,800.00
Residential (1–2 family): Residential fence (inspection included)
tiered rates by linears
Up to 100 linears
$75.00
Over 100 linears
$75.00 plus $15.00 per additional 100 linears
Residential (1–2 family): Manufactured home installation (occupancy permit, plus foundation strapping and skirting inspections)
$100.00 flat
Commercial / 3+ units: Commercial new building, addition, alteration or build-out (by valuation)
tiered rates by job value
Up to $1,000
$75.00
Over $1,000, up to $50,000
$200.00 plus $5.00 per additional $1,000
Over $50,000, up to $100,000
$445.00 plus $4.00 per additional $1,000
Over $100,000, up to $500,000
$645.00 plus $3.00 per additional $1,000
Over $500,000
$1,845.00 plus $2.00 per additional $1,000
Commercial / 3+ units: Commercial fence (inspection included)
tiered rates by linears
Up to 50 linears
$75.00
Over 50 linears
$75.00 plus $30.00 per additional 50 linears
Demolition of a building or structure (plus sewer disconnect fee)
tiered rates by sq ft
Up to 999 sq ft
$75.00
Over 999, up to 5,000 sq ft
$150.00
Over 5,000 sq ft
$300.00
Dumpster or trash enclosure built without a building permit (inspection included)
$115.00 flat
Residential or commercial generator (building permit, review included)
$350.00 flat
Swimming pool or spa (building permit, review included)
$450.00 flat
City Administrative Charge (does not apply to some listed rules)
10% of the permit fee (10% of each fee charged, including plan review and base fees)‡
Manufactured Home Foundation Strapping Inspection (select fee rules only)
$150.00
Manufactured Home Skirting Inspection (select fee rules only)
$150.00
Plan Review Fee (select fee rules only)
50% of the permit fee, jobs over $1,000 only
Sewer Disconnect Fee (demolition) (select fee rules only)
$75.00‡
Additional Inspection (building, site development or miscellaneous) (if applicable)
$75.00
Certificate of Occupancy When None Was Previously Issued (if applicable)
$200.00
Change of Occupancy in Group Classification (if applicable)
$200.00
Expired Permit Renewal (if applicable)
50% of the permit fee
Plan Check, Third and Later Submittals (select fee rules only) (if applicable)
50% of designated fees (50% of the original plan review fee)
Re-inspection Fee (if applicable)
$75.00
Replacement or Duplicate Certificate of Occupancy (if applicable)
$60.00
Residential Certificate (CO or CC) on Owner or Lender Request (if applicable)
$60.00
Special Inspection, Weekday After Hours (if applicable)
$150.00
Special Inspection, Weekend or City Holiday (if applicable)
$225.00

‡ Awaiting confirmation from the jurisdiction.

Sponsor This Page
Be the Featured General Contractor in Cut and Shoot

Homeowners and contractors planning a project check Cut and Shoot building permit fees here first. One sponsor per trade, flat monthly rate.

Advertise on This Page

Cut and Shoot Permit Fee Calculator

Pick a permit type and adjust the job value. Total updates instantly, itemized below.

Permit type
Project type
Kind of work

Cut and Shoot does not have a documented building fee for this project type in our sourced data yet. Check the official fee schedule linked above, or ask the building department.

Residential remodels and additions need no city building permit, so no estimate is shown for them. Work started without a permit pays double the permit fee. Commercial work of $50,000 or more also registers with the Texas Department of Licensing and Regulation (fee paid to the state).

Estimate only. Confirm with the Cut and Shoot building department before applying. Phone: (936) 264-3100. Permit fees only; excludes impact fees, utility connection charges, and other non-permit charges.

Sponsor This Page
Be the Featured General Contractor in Cut and Shoot

Homeowners and contractors planning a project check Cut and Shoot building permit fees here first. One sponsor per trade, flat monthly rate.

Advertise on This Page

How to Apply for a Permit in Cut and Shoot

Fill out the City's Residential Permit Application (online form on the Building Permits page, or the downloadable PDF) or the Commercial Permit Application, and submit it with plans to the City office. Bureau Veritas reviews plans and performs inspections for the City. Every contractor must register with the City before working inside the city limits (Contractor Registration Form with a copy of the driver's license and state license). All fees are paid to the City before the permit is issued. Remodels and additions to existing homes do not need a city permit; call the City office with questions.

Source: Cut and Shoot application instructions

Building Department Contact
Address
14391 Hwy 105 East, Conroe, TX 77306
Hours
Monday to Friday, 8 a.m. to 12 p.m. and 1 p.m. to 4:45 p.m.
Source
https://cutandshoot.org/city-secretary ; https://cutandshoot.org/contact-us

Cut and Shoot Permit Fee FAQs

How Much Does a Roofing Permit Cost in Cut and Shoot?

The roofing permit for a $20,000 residential re-roof runs $110.00, based on Cut and Shoot's sourced fee schedule.

How Are Permit Fees Calculated in Cut and Shoot?

Electrical and Plumbing permits are priced per inspection; Mechanical / HVAC permits are flat fees for the default job (Complete HVAC change-out or new system, inspections included), while new construction is priced per inspection; Roofing permits are flat fees. New construction is priced separately from remodel and alteration work; the calculator asks which kind of job yours is. Every rate comes straight from the sourced fee schedule above. Enter your job's details for an itemized total.

What Surcharges Are Added to Permits in Cut and Shoot?

On top of the base permit fee, the sourced schedule adds City Administrative Charge (10% of the permit fee (10% of each fee charged, including plan review and base fees)) and Plan Review Fee (50% of the permit fee, jobs over $1,000 only). Each is included in the estimates it applies to; the fee schedule above shows which permits and job types each one covers.

Where Do These Fees Come From?

Every figure on this page is sourced from City of Cut and Shoot Ordinance No. 135, Municipal Building Permit Inspection-Plan Review Fee Schedule (Exhibits A and B). See the official schedule. Last verified .

Other Jurisdictions in Montgomery County

Jobs inside another city's limits are permitted by that city; unincorporated areas by the county.

Unincorporated Montgomery CountyConroeCut and ShootMagnoliaMontgomeryOak Ridge NorthPanorama VillageShenandoahStagecoachWillisWoodloch
Contact

Get in Touch

Missing a jurisdiction? Spotted a fee that looks off? Request coverage for a city or county, report an issue, or ask about sponsorship. We typically reply within one business day.