FreeEvery fee straight from the official city and county fee schedules. No signup.

Georgetown, TX Permit Fees (2026)

Building, electrical, plumbing, mechanical/HVAC, and roofing permit fees for Georgetown, straight from the official fee schedule, with a free permit fee calculator below.

In Georgetown, a building permit for a remodel runs $170.00 in permit fees, a $20,000 re-roof $60.00, a $10,000 HVAC change-out $60.00, a $10,000 electrical panel upgrade or rewire $60.00, and a $10,000 whole-house repipe $60.00. Totals include the documented surcharges and minimum fees; where the schedule prices by unit, figures assume a 200 sq ft remodel area. Each figure is that single permit only: a job that combines trades, like a kitchen remodel with electrical and plumbing work, pays each applicable permit. Pick a project to load it in the calculator below.

Jump to Permit Fee Calculator
Source

City of Georgetown Building Permits & Inspections Fee Schedule (Revised 11/17/2026), building fees adopted by Res. 092722-D effective October 1, 2022

Covers building, electrical, plumbing, mechanical/HVAC, and roofing permits.

Apply online at the Georgetown permit portal, or call (512) 930-2550.

How Georgetown values a job: For new commercial buildings, Georgetown sets the valuation as the total square feet of the structure (excluding parking lot, driveway and sidewalk) multiplied by the ICC Building Valuation Data figure for its occupancy and construction type.

Schedules effective October 12, 2021 – October 1, 2022. Last verified: November 20, 2026

Georgetown Permit Fee Schedule

Every documented rule for each permit type, straight from the official schedule.

Building Permit Fees in Georgetown

Residential (1–2 family): Remodel, repair, addition, sunroom, accessory building, patio, deck, carport or garage
$0.50 per sq ft
Residential (1–2 family): New single-family home
$0.50 per sq ft (under roof, incl. garage, porches, patios)
Residential (1–2 family): Swimming pool (in-ground or above-ground), spa or hot tub
$100.00 flat
Residential (1–2 family): Demolition, per story per structure
$100.00 flat
Residential (1–2 family): Fence, water softener, or lawn irrigation system
$50.00 flat
Residential (1–2 family): Solar tubes, solar attic fans, or foundation repair
$50.00 flat
Commercial / 3+ units: Commercial remodel, alteration, addition, or tenant finish-out
$0.50 per sq ft
Commercial / 3+ units: New commercial building (by ICC building valuation)
tiered rates by job value‡
Each band charged as printed: base plus rate above the band floor; fee drops at $50,001 and $100,001
Up to $50,000
$250.00 plus $0.05 per additional $10
Over $50,000, up to $100,000
$350.00 plus $0.04 per additional $10
Over $100,000, up to $500,000
$460.00 plus $0.03 per additional $10
Over $500,000
$1,660.00 plus $0.02 per additional $10

‡ Awaiting confirmation from the jurisdiction.

Sponsor This Page
Be the Featured General Contractor in Georgetown

Homeowners and contractors planning a project check Georgetown building permit fees here first.

One sponsor per trade, flat monthly rate.

Georgetown Permit Fee Calculator

Pick a permit type and adjust the job value. Total updates instantly, itemized below.

Permit type
Project type
Kind of work
Job type

5 documented rates for this permit type; pick the one that matches your job.

sq ft
505,000 sq ft
Estimated building permit fee
$170.00
Included in this total
Building Permit Fee$100.00
200 sq ft × $0.50 per sq ft
Permit Application Fee (Residential Remodel or Addition)$60.00‡
Technology Fee$10.00
Total Estimate$170.00

‡ Awaiting confirmation from the jurisdiction.

Estimate only. Confirm with the Georgetown building department before applying. Apply online. Phone: (512) 930-2550. Permit fees only; excludes impact fees, utility connection charges, and other non-permit charges.

Sponsor This Page
Be the Featured General Contractor in Georgetown

Homeowners and contractors planning a project check Georgetown building permit fees here first.

One sponsor per trade, flat monthly rate.

How to Apply for a Permit in Georgetown

Apply online through My Government Online (MGO Connect) after creating an account: complete the permit application and upload the required construction documents. When the permit is approved, return to My Government Online to pay. Contractors must register with the city in My Government Online; trade (electrical, plumbing, mechanical) permits require a registered contractor. Schedule inspections in My Government Online by 3 p.m. for the next available business day; the city does not take inspection requests by phone. Residential plan review takes fifteen to twenty business days from acceptance; re-roof permits take ten to fifteen business days (residential) or up to thirty (commercial); commercial building permits take thirty business days, with no expedited review. Contact Building Inspections before applying if you are unsure whether Planning or Engineering approvals are needed first. Separate electrical, mechanical or plumbing permits are required when that work is part of a residential remodel; trade permits for new construction are included with the building permit.

Source: Georgetown application instructions

Apply online: Georgetown permit portal
Building Department Contact
Address
300-1 Industrial Ave., Georgetown, TX
Hours
8 a.m. to 5 p.m. Monday to Friday
Sponsor This Spot · Permit Help
Be the Featured Permit Expediter in Williamson County

Your name, phone and website right here, next to the building department's contact info, where people look right before they apply.

One expediter per county.

Georgetown Permit Fee FAQs

How Much Does a Building Permit Cost in Georgetown?

The building permit for a residential remodel runs $170.00, assuming a 200 sq ft remodel area (the schedule prices per unit), including the documented surcharges and minimum fees. The estimate is built from Georgetown's sourced fee schedule, and it covers the building permit alone; a job that combines trades pays each applicable permit. Calculate your job's value for an itemized total.

How Much Does a Roofing Permit Cost in Georgetown?

The roofing permit for a $20,000 residential re-roof runs $60.00, based on Georgetown's sourced fee schedule.

How Are Permit Fees Calculated in Georgetown?

A residential building permit is $0.50 per sq ft. Electrical, Plumbing, Mechanical / HVAC, and Roofing permits are flat fees. New construction is priced separately from remodel and alteration work; the calculator asks which kind of job yours is. Every rate comes straight from the sourced fee schedule above. Enter your job's details for an itemized total.

What Surcharges Are Added to Permits in Georgetown?

On top of the base permit fee, the sourced schedule adds Plan Review Fee (commercial) (50% of the permit fee). Each is included in the estimates it applies to; the fee schedule above shows which permits and job types each one covers.

Where Do These Fees Come From?

Every figure on this page is sourced from City of Georgetown Building Permits & Inspections Fee Schedule (Revised 11/17/2026), building fees adopted by Res. 092722-D effective October 1, 2022. See the official schedule. Last verified .

Other Jurisdictions in Williamson County

Jobs inside another city's limits are permitted by that city; unincorporated areas by the county.

Contact

Get in Touch

Missing a jurisdiction? Spotted a fee that looks off? Request coverage for a city or county, report an issue, or ask about sponsorship. We typically reply within one business day.